DIY Iron-Ons

A LITTLE CREATIVITY. A LOT OF PERSONALITY.

Your next favorite tee starts here.

Pick a design, grab your blank, and make it yours with our $3 DIY iron-on heat transfers.

Physical transfers only. Garments are not included. A heat press is required for the settings below.

Shop $3 Iron-Ons

Need a blank?

Choose a blank top, sweatshirt, tank, or matching set from our NJ inventory. Garments and iron-on transfers are sold separately.

Shop Blanks

Choose your design

Browse a group below, then select your design from the product dropdown. Each selected transfer is $3; you are not purchasing the entire group.

How to press your transfer

Check which transfer you selected before pressing. You Are So Loved — Puffed Up 3-D uses the special puff instructions below.

Standard transfers

  1. Heat press: Press at 310°F–320°F for 12 seconds with medium-to-high pressure. No garment pre-press needed.
  2. Peel: Wait about 5 seconds, then peel the film. Ninja Peel Technology allows a hot or cool peel.
  3. Recommended second press: Cover the exposed design with parchment paper or a guard sheet and press for another 12–15 seconds. This locks the ink into the fabric, reduces shine, and increases durability.

You Are So Loved — Puffed Up 3-D

Use these instructions instead of the standard directions for this option.

  1. Pre-press the blank garment for 6–8 seconds to remove moisture and wrinkles.
  2. Press at 350°F (175°C) for 7 seconds with medium-to-heavy pressure.
  3. No cover sheets: Do not use parchment paper, Teflon sheets, or upper platen covers. Direct heat triggers puff expansion.
  4. Peel hot: Peel the carrier immediately in one smooth, even motion.
  5. No second press: Pressing again will flatten the raised texture.